| DS2482OW(4) | Device Drivers Manual | DS2482OW(4) |
ds2482ow — Driver
for Maxim DS2482-100, DS2482-800, DS2483 and DS2484 IC2 to 1-Wire
bridge
ds2482ow* at iic? addr 0x18 Only one available to
the DS2483 and DS2484
ds2482ow* at iic? addr 0x19
ds2482ow* at iic? addr 0x1a
ds2482ow* at iic? addr 0x1b
ds2482ow* at iic? addr 0x1c DS2482-800 only
ds2482ow* at iic? addr 0x1d DS2482-800 only
ds2482ow* at iic? addr 0x1e DS2482-800 only
ds2482ow* at iic? addr 0x1f DS2482-800 only
onewire* at ds2482ow?
The ds2482ow driver provides 1 or 8
onewire(4) busses via an I2C
interface. The ds2482ow addr
argument selects the address at the
iic(4) bus. The chip generates
all of the needed 1-Wire pulses on its own and provides for the pullup
needed on the 1-Wire data line. The method that the chip uses for pullup can
be changed through sysctl(8)
nodes.
The following sysctl(3) variables are provided:
hw.ds2482ow0.pullup.activehw.ds2482ow0.pullup.strongIf neither active
pullup or strong pullup are enabled the chip willhw.ds2482ow0.debugDS2482_DEBUG, this
node will appear and can be used to set the debugging level.hw.ds2482ow0.port.tREC0hw.ds2482ow0.port.RWPUhw.ds2482ow0.port.standard.tRSTLhw.ds2482ow0.port.standard.tMSPhw.ds2482ow0.port.standard.tW0L| Parameter | tRSTL | tMSP | tW0L | tREC0 | RWPU |
| 0 | 440 | 58 | 52 | 2.75 | 500 |
| 1 | 460 | 58 | 54 | 2.75 | 500 |
| 2 | 480 | 60 | 56 | 2.75 | 500 |
| 3 | 500 | 62 | 58 | 2.75 | 500 |
| 4 | 520 | 64 | 60 | 2.75 | 500 |
| 5 | 540 | 66 | 62 | 2.75 | 500 |
| 6 | 560 | 68 | 64 | 5.25 | 1000 |
| 7 | 580 | 70 | 66 | 7.75 | 1000 |
| 8 | 600 | 72 | 68 | 10.25 | 1000 |
| 9 | 620 | 74 | 70 | 12.75 | 1000 |
| 10 | 640 | 76 | 70 | 15.25 | 1000 |
| 11 | 660 | 76 | 70 | 17.75 | 1000 |
| 12 | 680 | 76 | 70 | 20.25 | 1000 |
| 13 | 700 | 76 | 70 | 20.75 | 1000 |
| 14 | 720 | 76 | 70 | 25.25 | 1000 |
| 15 | 740 | 76 | 70 | 25.25 | 1000 |
The datasheet for the DS2483 or DS2484 should be consulted for more details on the meaning of these parameters.
The ds2482ow driver first appeared in
NetBSD 11.0.
The ds2482ow driver was written by
Brad Spencer
<brad@anduin.eldar.org>.
The DS248x chip family supports overdrive speed on a 1-Wire bus, but this driver does not support overdrive speed mode.
| October 31, 2024 | NetBSD 11.1 |